PRB: "VFP500.dll Is Invalid or Damaged" Error in VFP 5.0

ID: Q158064

The information in this article applies to:

Microsoft Visual FoxPro for Windows, versions 5.0, 6.0

SYMPTOMS

The error message "The file Vfp500.dll is invalid or damaged" appears when you try to run an executable on a machine that does not have Visual FoxPro installed This error occurs even if you have copied the Vfp500.dll file and the Vfp5enu.dll file to the /Windows/System folder.

CAUSE

This is caused by an outdated dynamic-link library (DLL). Oleaut32.dll. When you install Visual FoxPro, this DLL gets updated.

It has not been updated on the machine to which the executable has been copied. The Setup Wizard's setup program has not been used to install the executable on the destination system.

RESOLUTION

Use the Setup Wizard to create distribution disks, and install the application from them or create a netsetup and install from the network. The Setup Wizard takes care of updating Oleaut32.dll.

If you choose not to use the Setup Wizard use one of the two methods outlined below. The first method applies to Windows 95. The second method applies to Windows NT 3.51.

NOTE: If the Windows 95 method is used on a Windows NT 3.51 machine the machine is rendered UNBOOTABLE!

Windows 95

The outdated Oleaut32.dll file on the destination machine may be in use by other programs. Do not replace it while Windows is active. If you wish to just copy the Oleaut32.dll from the development machine, copy the file from the \Windows\System folder to a disk, then boot the destination machine to an MS-DOS prompt, and copy the file from the disk to that machine's \Windows\System folder.

Windows NT 3.51

Do not copy the Oleaut32.dll file to the Windows\System folder!

Follow the directions under the heading "To Update the Service Pack version of Oleaut32.dll" in the Readme.hlp file in the Visual FoxPro directory.

STATUS

This behavior is by design.

MORE INFORMATION

Steps to Reproduce Behavior

Create an executable that runs a simple program, such as one that executes a WAIT WINDOW command.

Copy the executable to another machine that does not have Visual FoxPro installed on it.

Copy the Vfp500.dll and the Vfp5enu.dll from the development system's \Windows\System folder to the destination system's \Windows\System folder.

Run the executable.

Additional query words: kbdsd VFoxWin

Keywords : kbsetup kbVFp500 kbVFp600 FxenvGeneral FxsetupGeneral FxtoolDk
Version : WINDOWS:5.0,6.0
Platform : WINDOWS
Issue type :