FIX: ODBC Files Get Copied to Distribution Disks in VFP 3.0

ID: Q164389

The information in this article applies to:
  • Microsoft Visual FoxPro for Windows, versions 3.0, 3.0b

SYMPTOMS

When leaving the ODBC Drivers check box blank in step 2 of the Setup Wizard in Visual FoxPro 3.0, the desired effect is to avoid having the ODBC files copied to the disk images. The problem is that some of the ODBC files get copied to the disk images even if the ODBC check box is clear.

There are at least seven files that get copied onto the disk images. They are listed below:

  • Odbccp32.dl_


  • Odbcinst.dl_


  • Odbcint.dl_


  • Odbckey.dl_


  • Odbcstf.dl_


  • Odbcstp.dl_


  • Odbcexec.ex_



RESOLUTION

To ensure that these files do not get copied onto the disk images, complete the following steps:

  1. Delete the Visual FoxPro \Distrib directory.


  2. Open the Compress.dbf table in the Visual FoxPro \Distrib.src directory and make a backup of it.


  3. Create an index on the DEST field. Locate Odbc.dl_ in the DEST field. Move the record pointer to that record.


  4. Issue the following command in the Command window: 
    
      DELETE NEXT 52
    Browse the table to make sure that only names that start with OD in the DEST field are marked for deletion. There might be more than 52 records that start with OD. If so, mark them for deletion also.


  5. Now that the ODBC files are marked for deletion in the Compress table, pack the table and close it.


  6. Delete the Compress and Disk images directories under the destination directory if they have been created from an earlier session of the Setup Wizard. Also delete the Dkcontrl.dbf, Dkcontrl.cdx, and Wzsetup.ini files located in the directory where the source files are.


  7. Run the Setup Wizard to rebuild the Visual FoxPro \Distrib directory and the Disk images directories. Note that opening up each of the disk images shows that there are no ODBC files now.


  8. Open the Setup.st1 file in the DISK1 directory with Notepad and place a semicolon at the beginning of any line that represents an ODBC file. The semicolon acts as a remark statement allowing the setup routine to bypass that line. This step has to be repeated every time the Disk images are re-created.


To be able to change back to checking the ODBC drivers check box in the Setup Wizard and loading the ODBC files into the Disk images directories, replace the Compress.dbf file in the Visual FoxPro \Distrib.src directory with the backup that was created and delete the Visual FoxPro \Distrib directory. Running the Setup wizard re-creates the Distrib directory and add the ODBC files to the Disk images.


STATUS

Microsoft has confirmed this to be a problem in the Microsoft products listed at the beginning of this article. This problem was fixed in Visual FoxPro 5.0.


MORE INFORMATION

Steps to Reproduce Behavior

  1. Create an .exe file and place it in a directory by itself.


  2. Run the Setup Wizard on that directory and leave the ODBC drivers check box clear.


  3. Open each of the Disk images directories and note that the ODBC files listed above are in the directories.


  4. Perform the steps in the WORKAROUND section to remove the ODBC files from the disk images directories.


Additional query words:

Keywords : kbVFp300bbug buglist3.00 FxsetupGeneral FxtoolWizother
Version : WINDOWS:3.0,3.0b
Platform : WINDOWS
Issue type :


Last Reviewed: February 3, 2000
© 2000 Microsoft Corporation. All rights reserved. Terms of Use.