Network and Mouse Conflicts

ID: Q28421


The information in this article applies to:
  • Microsoft Mouse Driver for MS-DOS, versions 6.x, 7.x, 8.x, and 9.0


SUMMARY

The bus mouse is interrupt-selectable using the J4 jumper block located on the INPORT interface card.

Make sure the netcard is not using the same interrupt; if your network card is using the same interrupt, it will crash when the mouse driver installs.


MORE INFORMATION

The bus mouse uses its own I/O address (23c-23f). On the current interface cards, this can be changed to the lower four bytes by selecting secondary INPORT (address 238-23b) over PRIMARY on the J3 jumper setting.

NOTE: Moving the card to another slot may also solve the problem.)

If the above does not solve the problem or if you have the serial mouse, change the driver loading order or disable the driver (mouse off) when using the network.

Contact the manufacturers of your netcard to see if they know of the above problem.

Additional query words: noupd 6.x 7.x 8.00 8.20 9.00

Keywords :
Version : 6.x 7.x 8.x 9.00
Platform : MS-DOS
Issue type :


Last Reviewed: August 9, 1999
© 2000 Microsoft Corporation. All rights reserved. Terms of Use.