X400: Manually Adding TP4/CLNP Peer Address to Node

ID: Q115551

The information in this article applies to:

Microsoft Mail Gateway to X.400, version 3.2

SUMMARY

Version 3.2 of Microsoft Mail Gateway to X.400 supports the ES to IS routing protocol within its CLNP layer, so you can run it over a TP4/CLNP network.

These systems send ES-hellos and answer the ES-hellos of other systems, and this makes them automatically aware of other nodes' network addresses.

If a node cannot send or answer ES-hellos, you must manually add its network address at the node by running the following command on the system on which you are running the gateway TP4/CLNP:

addrte NSAP MAC

To ensure that the remote network SAP value and MAC address were correctly added, run the ESQ command.

For more information, see the "TP4/CLNP Configuration and Utilities Guide."

Additional query words: 3.20

Keywords :
Version : MS-DOS:3.2
Platform : MS-DOS
Issue type :