MHS: Gateway to MHS INSTALL.EXE Version 3.0.1 Update

ID: Q124955

The information in this article applies to:

Microsoft Mail Gateway to MHS, version 3.0
Microsoft Mail Gateway to MHS Access, version 3.0

SUMMARY

Microsoft provides a replacement for the INSTALL.EXE file that is included with version 3.0 of Microsoft Mail Gateway to MHS and version 3.0 of Microsoft Mail Gateway to MHS Access.

For complete information about obtaining and installing the INSTALL.EXE file, see the following sections:

To download the updated files

To replace your INSTALL.EXE file

MORE INFORMATION

This update corrects the following problem:

The installation procedure runs out of memory and is unsuccessful on postoffices if more than 429 postoffices are already defined in the Mail Administrator program (ADMIN.EXE).

To download the updated file

The files listed below are available to download from the Microsoft Download Center. For information on how to download these files, please see the "To download the updated files" section below.

FILES AVAILABLE FROM ONLINE SERVICES


 Item ID      Filename     Description
-----------------------------------------------------------
S15128       MHSGINST.EXE  Update for Microsoft Mail
                           Gateway to MHS
S15129       MHSAINST.EXE  Update for Microsoft Mail
                           Gateway to MHS Access

To download the updated files

The following files are available for download from the Microsoft Download Center. Click the file names below to download the files:

Mhsainst.exe

Mhsginst.exe

For more information about how to download files from the Microsoft Download Center, please visit the Download Center at the following Web address

http://www.microsoft.com/downloads/search.asp

and then click How to use the Microsoft Download Center.

After you download MHSGINST.EXE or MHSAINST.EXE to a clean directory, run it (by typing mhsginst or mhsainst, respectively, at the MS-DOS prompt) to extract the contents of the file. You should receive the following files:

MHSGINST.EXE:
INSTALL.EXE (40,233 bytes, dated 12-20-94, 8:59 A.M.)
README.TXT

MHSAINST.EXE:
INSTALL.EXE (42,345 bytes, dated 12-19-94, 1:51 P.M.)
README.TXT

To replace your INSTALL.EXE file

At the MS-DOS command prompt, type the following and press ENTER
copy <path>:\install.exe <destination>
where <path> is the drive and directory where you ran the self extracting MHSGINST.EXE or MHSAINST.EXE file and <destination> is the drive and directory where your Gateway to MHS or Gateway to MHS Access disk currently resides. For example, if you ran the self-extracting file from the TEST directory on drive D, and your gateway disk is located in drive A, type the following commands:
copy d:\test\install.exe a:

Follow the installation steps as outlined in the Microsoft Mail Gateway to MHS "Administrator's Guide."

Additional query words: 3.00

Keywords : MailGWMHS
Version : MS-DOS:3.0; :3.0
Platform : MS-DOS
Issue type :