ADT2: WX1200 OLE Controls Cause Error Without OLE 2.02 or Later

ID: Q146883


The information in this article applies to:
  • Microsoft Access Developer's Toolkit, version 2.0
  • Microsoft Access 2.0


SYMPTOMS

When you attempt to use the OLE controls included in the Microsoft Access Developer's Toolkit OLE (Custom) Controls Service Pack, you may receive an error message unless you have OLE version 2.02 or later installed on your computer. When you use these OLE controls in Windows NT 3.51 or Windows 95 using the OLE version 2.01 DLLs included with Microsoft Access 2.0, you may also receive an error message. When you run code that references these OLE controls, Microsoft Access may prompt you to input a value or may generate a generic error message.


CAUSE

The DLLs required to support the new OLE controls must be OLE 2.02 or later. For more information about this topic, please see the following article in the Microsoft Knowledge Base:

ARTICLE-ID: Q123593
TITLE: ACC2: OLE 2.02 Required to Use Custom Controls


RESOLUTION

Install OLE version 2.02 or later. OLE 2.02 is available with the Microsoft Access version 2.0 Service Pack. For information about how to obtain the Service Pack, please see the following article in the Microsoft Knowledge Base:

ARTICLE-ID: Q122927
TITLE : WX1124: Microsoft Access Version 2.0 Service Pack

Additional query words: adt automation

Keywords : kberrmsg kbinterop
Version : WINDOWS:2.0
Platform : WINDOWS
Issue type : kbprb


Last Reviewed: July 22, 1999
© 2000 Microsoft Corporation. All rights reserved. Terms of Use.