The information in this article applies to:
SYMPTOMS
When you copy an AutoShape from any of the programs listed at the beginning
of this article, and then paste the AutoShape into a program that is not
included in Microsoft Office 97, you may notice one or more of the
following problems:
CAUSE
These problems may occur when you copy an AutoShape, and then paste it into
either of the following programs:
WORKAROUND
You may be able to work around these problems by first pasting the
AutoShape into another program, such as Microsoft Paint. If you then copy
the AutoShape from Microsoft Paint and paste it into another program, the
problems described in the "Symptoms" section in this article may not occur.
STATUSThis problem occurs when you use Microsoft Office 97 and Corel Draw 6.x or HiJaak PRO for Windows 95. This is a known problem that occurs when you paste enhanced metafiles, such as AutoShapes, into certain programs. Note that the problem does not occur when you paste an AutoShape into any of the programs included in Microsoft Office 97. MORE INFORMATION
In the programs included in Microsoft Office 97, an AutoShape is stored as
an enhanced metafile (EMF). If you copy an AutoShape and paste it into
another program, the other program may incorrectly handle the copied EMF.
As a result, the pasted AutoShape may appear differently than the original
AutoShape. These problems may also occur if you use the Paste Special
command (if available) to paste the copied AutoShape into another program.
Additional query words: XL97 WD97 PP97
Keywords : kbinterop xldraw offinterop |
Last Reviewed: June 2, 1999 © 2000 Microsoft Corporation. All rights reserved. Terms of Use. |