The information in this article applies to:
SYMPTOMSWhen you save a document in Word for Windows, the following error message may occur if you run Word under Windows for Workgroups in standard mode: A similar error message may occur when Word performs an autosave operation:
CAUSEThis happens when you run Word under Windows for Workgroups in standard mode if the parameters for the SHARE.EXE utility are set too low or if no parameters are set (which causes Share to use its default settings). The Word Setup program adds the following line to your AUTOEXEC.BAT file to load Share: <path>\SHARE.EXE /L:500 /F:5100where <path> is the drive and directory where the SHARE.EXE file is located (usually the MS-DOS directory). This may also occur if you are using Windows for Workgroups version 3.11 and the line, DEVICE=IFSHLP.SYS is missing or misspelled in CONFIG.SYS file. RESOLUTION
If your Share settings are lower than the ones listed above, you must
modify them in your AUTOEXEC.BAT file.
share.exe and config.sys and autoexec.bat and word and 6.0 WORKAROUNDFrom the File menu select Save As. From the Save File as Type drop-down scroll box select, Rich Text Format and choose OK. MORE INFORMATION
To run Word 6.0 under Windows version 3.1 or Windows for Workgroups
version 3.1 in standard mode, you must run the MS-DOS SHARE command
before starting Windows. Word uses Share for object linking and
embedding (OLE) version 2.0 operations. Specifically, Share provides
the range-locking functionality that Word uses in compound files.
Word 6.0 will not start under Windows 3.1 or Windows for Workgroups
3.1 in standard mode unless SHARE.EXE is loaded.
Additional query words: 6.0 msdos configuration winword word6
Keywords : kbsetup |
Last Reviewed: September 21, 1999 © 2000 Microsoft Corporation. All rights reserved. Terms of Use. |