The information in this article applies to:
SYMPTOMSIn a document formatted for variable-width columns, text may wrap so that only one character appears on each line, as shown in the following example:
CAUSE
Text wraps after one character in a variable-width-column section if you
set a paragraph indent value that is too large for the current column
width. When you create variable-width columns (by clearing the Equal Column
Widths option and setting unequal width values, or by selecting the Left or
Right preset in the Format Columns dialog box), Word relaxes the error
checking criteria for valid indent values, so no error message appears to
notify you that you have set an indent that is too large for the column
width. For example, no error message appears if you set a 4-inch right
indent in a 3-inch column, but all the text wraps after one character.
STATUSThis is by design in Word for Windows. This is not a problem in Word for the Macintosh. WORKAROUNDAdjust the paragraph indent settings so the indent fits within the column width. MORE INFORMATIONError checking was relaxed for variable-width columns because Word does not calculate valid indent values based on the current column, but rather calculates based on the AVERAGE width of the columns. If Word used this model to error check the indents in a variable-width-column section, some valid indents would not be allowed. For example, if one column is .5 inch wide and the other is 5 inches wide, the average column width is 2.75 inches, which means that Word would not allow an indent of more than 2.75 inches in the 5-inch column. To prevent this problem, error checking for variable-width columns uses the entire page width (minus the margins) as the maximum allowable indent value. Additional query words: 6.0 winword macword word6
Keywords : kbformat |
Last Reviewed: December 28, 1999 © 2000 Microsoft Corporation. All rights reserved. Terms of Use. |