WD97: Error: "Cannot Access the File" After File Closed (ODMA)

ID: Q179435


The information in this article applies to:
  • Microsoft Word 97 for Windows


SYMPTOMS

When you are running Word 97 in a Document Management System (DMS) that uses the ODMA API, you may receive the following error message after copying a large amount of text and closing the document:

  • The process cannot access the file because it is being used by another process.
  • -or-
  • <document name> is in use by another application.
These error messages will occur when the DMS attempts to move or catalog the original Word document.


CAUSE

This problem occurs because when you use the Cut or Copy commands to copy information, Word makes a copy of the information, saves it in memory, and makes a note of where the copied data is stored (Word caches the data). Word incorrectly keeps the pointer to this cached information after allowing the file to be closed. The error message is displayed when DMS attempts to move or catalog the original Word document.


RESOLUTION

To correct this problem, obtain Microsoft Word 97 Service Release 2 (SR-2). information.


STATUS

Microsoft has confirmed this to be a problem in the Microsoft products listed at the beginning of this article. This problem was corrected in Microsoft Office 97 Service Release 2 (SR-2).

For additional information about SR-2, please see the following article in the Microsoft Knowledge Base:

Q151261 OFF97: How to Obtain and Install MS Office 97 SR-2


REFERENCES

For additional information, please see the following articles in the Microsoft Knowledge Base:

Q174304 WD97: Save As Command Does Not Close the Previous Document

Q159963 WD97: Word 97 Supports ODMA

Additional query words: PCDocs PC Docs groupwise novell saveas saveas.dot legal

Keywords : kb3rdparty kbinterop word97
Version : WINDOWS:97
Platform : WINDOWS
Issue type : kbbug


Last Reviewed: August 11, 1999
© 2000 Microsoft Corporation. All rights reserved. Terms of Use.