ACC1x: Error Using Automatic ODBC Setup with Auto Switch

ID: Q109333

The information in this article applies to:

Microsoft Access versions 1.0, 1.1

SYMPTOMS

Page 663 of the Microsoft Access "User's Guide," version 1.0, and page 673 of the Microsoft Access "User's Guide," version 1.1, contains instructions for creating an ODBC installation disk or directory, and for setting up ODBC automatically.

If you follow these instructions, you will receive the error message:

Setup is unable to install ODBC. C:\~MSODBC.T\ODBCINST.INI is either empty or missing.

CAUSE

There is a step missing in the instructions. The [FILES] section of the SETUP.LST file is missing two lines.

RESOLUTION

To correct this problem, open the SETUP.LST file in any text editor, such as Windows Notepad. The SETUP.LST file is located on your ODBC disk, or in the directory where the ODBC files were copied. Add the following two lines to the [FILES] section:


   ODBC.INI = ODBC.INI
   ODBCINST.INI = ODBCINST.INI

Run the Setup program again.

REFERENCES

Microsoft Access "User's Guide," version 1.0, page 663

Microsoft Access "User's Guide," version 1.1, page 673

Keywords : kbsetup StpOdbc
Version : 1.0 1.1
Platform : WINDOWS
Issue type :