Ethernet_802.3 Does Not Work with ODI/NDIS Support Driver
ID: Q124798
|
The information in this article applies to:
-
Microsoft Windows NT Server version 3.5
-
Microsoft Network Client version 3.0 for MS-DOS
SYMPTOMS
When you use the ODI/NDIS Support driver and configure the NWLink IPX
Compatible Transport protocol with the frame type of Ethernet_802.3 in
Network Client version 3.0 for MS-DOS that is shipped with Windows NT
Server version 3.5, the following message may appear when you attempt to
log on to a Windows NT version 3.5 domain:
You were logged on, but have not been validated by a server. Therefore,
you may not have permission to use some network resources.
WORKAROUND
To work around this problem, either run the Network Client version 3.0 for
MS-DOS Setup program or modify its PROTOCOL.INI file:
Run Network Client Setup Program
- Run the Setup program for Network Client version 3.0 for MS-DOS and
select Change Network Configuration.
- For the Protocol, select NWLink IPX Compatible Transport, and for
Options, select Change Settings.
- Select either one of the following for Frame Type:
Ethernet _802.2
Ethernet_II
Ethernet _SNAP
- Exit Setup and restart the computer.
- On the Windows NT Server version 3.5, verify that you have the same
frame type configured for the NWLink IPX/SPX Compatible Transport
protocol in Network of Control Panel.
Modify PROTOCOL.INI
- Using a text editor such as EDIT.COM, open the PROTOCOL.INI file
for the Network Client.
- In the [MS$NWLINK] section of PROTOCOL.INI, change the following:
[MS$NWLINK]
FRAME=Ethernet_802.3
to
[MS$NWLINK]
FRAME=Ethernet_802.2 (or Ethernet_II or Ethernet_SNAP)
- Save and exit the text editor, and reboot the computer.
STATUS
Microsoft has confirmed this to be a problem in the Network Client version
3.0 for MS-DOS. We are researching this problem and will post new
information here in the Microsoft Knowledge Base as it becomes available.
Additional query words:
prodnt 3.10 3.11
Keywords : NTInterop
Version : winnt:3.5
Platform : winnt
Issue type :