Using RASCOPY.BAT To Install Remote Access Service 1.1a

ID: Q138810

The information in this article applies to:

Microsoft Network Client for MS-DOS version 3.0
Microsoft Remote Access Service, version 1.1a

The README.TXT file included with the Microsoft Network Client version 3.0 includes instructions describing how to install Remote Access Service (RAS) 1.1a. You are instructed to run the file RASCOPY.BAT after installing the Network Client software. RASCOPY.BAT will prompt you for RAS 1.1a Disks 1 and 2, even though there is only one setup disk for RAS 1.1a.

When you are prompted for RAS 1.1a Disk 2, simply press enter on the keyboard to continue without removing RAS 1.1a Disk 1. All files needed to setup RAS 1.1a are located on Disk 1.

Additional query words: 1.10a

Keywords : ntras
Version : MS-DOS:3.0; :1.1a
Platform : MS-DOS
Issue type :