The information in this article applies to:
SYMPTOMS
When you are using Windows 95 to access a mapped network drive that is
larger than 2 gigabytes (GB) in size (for example, an NTFS or FAT volume
shared by a Windows NT server), Windows 95 reports only 2 GB of disk space
for the network drive.
RESOLUTION
To work around this behavior for a local hard disk that uses the FAT32
file system, install Microsoft Internet Explorer 4.0 with the Windows
Desktop Update component. Note that this method does not work around this
behavior with network drives.
http://www.microsoft.com/ie/ STATUSThis behavior is by design for network drives. MORE INFORMATIONBoth Microsoft MS-DOS and Windows 95 use a 16-bit FAT for logical drives larger than 15 megabytes (MB). The maximum number of clusters for a 16-bit FAT drive is 64K, or 65,536 bytes (where 1K = 1024 bytes). In addition, the maximum cluster size in MS-DOS and Windows 95 is 32K, or 32,768 bytes. Based on this information, the maximum logical drive size in MS-DOS and Windows 95 is calculated as follows:
Note that when you connect to a network share using a UNC connection and
you check the properties of a folder on the network share, Windows 95
(retail and OEM Service Release 2) accurately reports its size up to 4 GB.
If the network share's size exceeds 4 GB, the properties for the folder
show the byte counter properly incrementing up to 4 GB, and then the
counter resets back to 0 and resumes counting. For example, with a 4.5-GB
share, the counter counts up to 4 GB, starts over at 0, and then continues
incrementing up to 500 MB.
To maintain compatibility with MS-DOS-based and Windows-based programs that assume a 2-GB drive size limit, the Windows 95 network redirector (Vredir.vxd) never reports more than 2 GB of total or available disk space on network drives. Additional query words: 1.99 large partition
Keywords : kb3rdparty kbnetwork kbtool diskmem win95 |
Last Reviewed: May 24, 1999 © 2000 Microsoft Corporation. All rights reserved. Terms of Use. |