The information in this article applies to:
SUMMARYWindows 95 does not include an anti-virus program similar to the Microsoft Anti-Virus program included with Microsoft MS-DOS versions 6.0 and later. However, Windows 95 includes several features that make it extremely difficult for viruses to infect your computer. This article discusses these features, and explains how the features make it difficult for viruses to infect your computer. The following topics are discussed in this article:
MORE INFORMATIONBlocking Direct Disk AccessSome viruses and other programs attempt to bypass the operating system and system ROM BIOS and use INT25h or INT26h to write to the hard disk directly. When a program attempts to access the hard disk in this manner, Windows 95 prevents the program from doing so and displays the following error message:
This feature prevents many viruses from infecting your computer and damaging the data on your hard disk. Recognizing Master Boot Record (MBR) ModificationsMost viruses infect your computer by modifying the MBR and hooking the INT13h chain. This allows the virus to monitor hard disk access and damage the data on your hard disk. Windows 95 prevents this type of virus from damaging your data by maintaining a list of the programs that are currently hooking the INT13h chain. Each time you start your computer, Windows 95 checks to see which programs are monitoring the INT13h chain, and then compares this list of programs with the list that it recorded the last time Windows 95 started. If any new programs that Windows 95 does not recognize have hooked the INT13h chain, the following message is displayed:If you click Yes, the Performance tab in System Properties is displayed, which provides more information and allows you to begin troubleshooting the problem. This situation is most likely to occur when you start an operating system other than Windows 95 using a bootable floppy disk. If the floppy disk is infected with a virus, the virus will most likely modify the MBR on the hard disk and hook the INT13h chain. When you remove the floppy disk and start your computer normally, Windows 95 recognizes that the MBR has been modified and that the INT13h chain has been hooked by an unknown program. The warning you receive gives you an opportunity to remove the virus before it can damage your data. When a virus modifies the MBR, the Performance tab in System properties and the Ios.log file typically report that a file called Mbrint13.sys is causing drives to be accessed in MS-DOS Compatibility mode. To access the Performance tab, double-click the System icon in Control Panel, and then click the Performance tab. Identifying Unknown Device DriversWindows 95 maintains a list of all the real-mode device drivers that it can safely replace with its own protected-mode drivers. If you add a new device driver that hooks the INT13h or INT21h chain, and the driver is not on the list of drivers that can safely be replaced, Windows 95 is forced to access drives using MS-DOS Compatibility mode instead of protected mode. When this occurs, the following message is displayed:A new MS-DOS resident program named '<filename>' may decrease your system performance. Would you like to see more information about this problem?where <filename> is the name of the new device driver. If you click Yes, the Performance tab in System Properties is displayed, which typically identifies the driver that is causing the problem and shows you how to remove the driver from your computer. This feature allows Windows 95 to identify those viruses that propagate from a device driver instead of modifying the MBR. By identifying device drivers that it does not recognize, Windows 95 gives you an opportunity to investigate the situation and remove any viruses before they can damage your data.
Keywords : win95 |
|
Last Reviewed: May 19, 1999 © 2000 Microsoft Corporation. All rights reserved. Terms of Use. |