The information in this article applies to:
SYMPTOMSWhen you try to run the DISKCOPY command from the Run command on the Start menu to copy from one 3.5-inch floppy disk drive to another identical drive, you may receive the following error message:
RESOLUTIONTo work around this behavior, use any one of the following methods: Method 1Run the DISKCOPY command in MS-DOS mode. To do so, follow these steps:
Method 2Disable protected-mode support for the floppy disk controller. This causes the floppy disk drives to operate in MS-DOS Compatibility mode. To do so, follow these steps:
Method 3Manually copy the information from the source disk to the destination disk.STATUSMicrosoft is researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available. MORE INFORMATION
This problem does not occur on computers with one 3.5-inch floppy disk
drive and one 5.25-inch floppy disk drive, or on computers with two 5.25-
inch floppy disk drives.
Keywords : kberrmsg kbhw win95 win98 |
Last Reviewed: June 23, 1999 © 2000 Microsoft Corporation. All rights reserved. Terms of Use. |