Switch Settings For Non-PS/2 Token-Ring Adapters
ID: Q32845
|
The information in this article applies to:
-
Microsoft Windows versions 1.x, 3.0, 3.0a, 3.1, 3.11
SUMMARY
This article discusses switch settings for the IBM Token-Ring Network PC
Adapter.
The following are switch-configurable parameters for the Token Ring
adapter and conflicts that may occur:
- The Interrupt Line address may conflict with devices such as the
Microsoft Bus Mouse, hard drive controllers, serial and parallel
ports.
- The Base I/O address may conflict with expanded memory boards.
- The Memory Map Address may conflict with the memory addresses
used by expanded memory board drivers, 3270 cards, ESDI
hard-drive controllers, and display adapters.
It may be necessary to change switch settings on the Token Ring
Adapter and/or other cards in the system to avoid such conflicts.
MORE INFORMATION
The following are Interrupt Line switch settings:
(Switch Block 1)
Interrupt 2 - Switches 7 and 8 on (cascade to IRQ 9)
Interrupt 3 - Switch 7 on, switch 8 off (normally COM2)
Interrupt 6 - Switch 7 off, switch 8 on (normally floppy
controller)
Interrupt 7 - Switches 7 and 8 off (normally LPT1)
The following are Base I/O Address switch settings:
(Switch Block 2)
Address A20h - switch 2 off
Address A24h - switch 2 on
The following are Memory Map Address switch settings:
(Switch Block 1)
Address CC00 - Switches 1,4, and 5 off
Switches 2,3, and 6 on
Address CC00 - Switches 1,4,5, and 6 off
Switches 2 and 3 on
Address A400 - Switches 2 and 5 off
Switches 1,3,4, and 6 on
Address C400 - Switches 1 and 5 off
Switches 2,3,4, and 6 on
Additional query words:
1.x 2.03 2.10 2.11 3.00 3.10 win30 win31 3.11
Keywords :
Version : WINDOWS:1.x,3.0,3.0a,3.1,3.11
Platform : WINDOWS
Issue type :