DFI 200h Mouse Settings Switch for Windows 3.0

ID: Q66724

The information in this article applies to:

Microsoft Windows versions 3.0, 3.0a

SYMPTOMS

You may have difficulty using the DFI 200H series mouse with Microsoft Windows version 3.0. For example, the mouse pointer may appear but not function, or the mouse pointer may be unavailable.

CAUSE

The switch on the mouse may be set up incorrectly.

RESOLUTION

The DFI 200H series mouse has a sliding button located on the side of the mouse. There are two settings that indicate the following:


   2 - for two-button mouse operation
   3 - for three-button mouse operation

Be sure that the switch is set for a two-button mouse.

To enable the mouse, you should place one of the following device statements in either the AUTOEXEC.BAT file or the CONFIG.SYS file.

NOTE: Do not use both statements at the same time. Use one or the other.

AUTOEXEC.BAT


   C:\DFIMOUSE\DFIMOUSE /Y

CONFIG.SYS


   DEVICE=C:\DFIMOUSE\DFIMOUSE.SYS

Additional query words: 3.00 3.0 3.0a 3.00a 3rdparty two three button KBHW

Keywords :
Version : WINDOWS:3.0,3.0a
Platform : WINDOWS
Issue type :