Windows and Epson MX-80, FX-80, RX-80, MX-100
ID: Q67504
|
The information in this article applies to:
-
Microsoft Windows versions 3.0, 3.0a, 3.1, 3.11
SUMMARY
The Epson Series-80, the FX, RX, and MX (older versions) may not print
correctly with Microsoft Windows without a ROM upgrade, which is available
from Epson.
To test to see if your Epson printer needs this ROM upgrade, do the
following:
- Turn off the printer.
- Turn the printer back on while holding down the line feed button.
- The printer will begin to do a self test. If the printer keeps
printing after three to four lines, you need the graphics upgrade.
If it stops, you already have the upgrade installed, or you have a
newer printer with the ROM upgrade built in.
MORE INFORMATION
The upgrade is called Dots Perfect; it is a chip that fits on the
printer board.
To order Dots Perfect, contact Epson.
You will need to specify your printer model and type because there is
a different chip for each model. This chip will also allow your
printer to print graphics.
For more information about the Epson 9-pin series printers, query on
the following words:
Epson and MX and Series and Firmware and Requirements and Windows
The Epson products included here are manufactured by a vendor independent
of Microsoft; we make no warranty, implied or otherwise, regarding these
products' performance or reliability.
Additional query words:
3.00 win30 win31 3.10 3.11 3rdparty
Keywords :
Version : WINDOWS:3.0,3.0a,3.1,3.11
Platform : WINDOWS
Issue type :
|