Troubleshooting Windows 3.0 Standard Mode Problems

ID: Q68649


The information in this article applies to:
  • Microsoft Windows versions 3.0, 3.0a


SUMMARY

You may experience problems running Microsoft Windows version 3.0 in standard mode. These problems include the following:

  • Windows hanging at the logo screen


  • Unrecoverable Application Errors (UAEs)


  • Windows defaulting to real mode even when you type Win



MORE INFORMATION

The following steps may reduce problems running Microsoft Windows version 3.0 in standard mode:

  1. Ensure that the system has at least an 80286 processor and has enough memory to run in standard mode. You need between 384K to 512K of combined conventional and extended memory to run Windows in standard mode. You should have at least 128K free conventional memory and at least 192K free extended memory.


  2. Verify that Windows can run in real mode. If so, you may have installed mouse, keyboard, video, or printer drivers designed for an earlier version of Windows. These drivers often prevent Windows from running in standard mode. Update to the proper Windows 3.00 driver. If Windows doesn't run in real or standard mode, you may have selected the wrong driver or computer type. Reinstall Windows.


  3. Check your AUTOEXEC.BAT and CONFIG.SYS files for TSRs (terminate-and-stay-resident programs), sufficient buffers, files, and environment space. For more information on troubleshooting the AUTOEXEC.BAT and CONFIG.SYS files, query on the following words:
    tshoot and AUTOEXEC.BAT


  4. Verify that Windows 3.00 is correctly installed on the system by clicking the Setup icon from the Main group of Program Manager. Check that the correct keyboard, pointing device, video driver, and network were chosen during setup. Also check through the "Microsoft Windows Version 3.00 Hardware Compatibility List" to see if your computer requires special handling. If so, exit Windows and reinstall, using only minimum drivers (no mouse, no network, lower-resolution video driver) with the SETUP/I option.


  5. Disable the autoswitching or autosensing feature on the video card if applicable.


  6. Disable RAM shadowing if supported by the system.


  7. Verify that you are using the correct version of DOS for the system. You should be using a DOS version 3.10 or later that was designed for the machine. For example, do NOT use IBM PC DOS on non-IBM computers and vice-versa.


  8. Ensure that HIMEM loads successfully. If not, try ALL A20 handlers 1 to 8. The CONFIG.SYS file should include the /m:x switch on the DEVICE=C:\HIMEM.SYS line, where x denotes a handler from 1 to 8. For example, if you are using a PS2, this line should read DEVICE=C:\HIMEM.SYS /M:2. Some A20 handlers may lock up your computer. As a result, have a bootable DOS floppy disk available in case of problems.


  9. Install Windows in a clean directory. Do not install Windows version 3.00 over a 2.x version of Windows because some files and drivers may not get updated properly.


  10. Confirm that you are using a recent system BIOS. If not, you may want to contact the manufacturer for an update.


  11. Some 286 computers may not run Windows in standard mode unless you put the statement PadCodeSegments=1 in the [Standard] section of the SYSTEM.INI file.


Additional query words: 3.00 3.00a win30

Keywords : win30
Version : WINDOWS:3.0,3.0a
Platform : WINDOWS
Issue type :


Last Reviewed: September 28, 1999
© 2000 Microsoft Corporation. All rights reserved. Terms of Use.