Configuring GENIUS Mice for Microsoft Windows 3.0

ID: Q69392

The information in this article applies to:
  • Microsoft Windows versions 3.0, 3.0a

SUMMARY

This article contains instructions on how to configure the following GENIUS mice for use with Microsoft Windows 3.0:

  • GENIUS GM-6X


  • GENIUS GM-F302


  • GM-F303


  • GM-6000



MORE INFORMATION

GENIUS GM-6X

The GENIUS GM-6X mouse is a three-button mouse that does not emulate the Microsoft Mouse. Configure the mouse for use with Windows as follows:
  1. Install the Windows Mouse Systems (or Vision) on COMx.


  2. Remove the Microsoft MOUSE.SYS mouse driver from the CONFIG.SYS file if installed.


  3. Insert GMOUSE.COM in the AUTOEXEC.BAT file.


  4. Save your changes and restart your system.


GENIUS GM-F302, GM-F303, or GM-6000

These three models can emulate either a Mouse Systems Mouse or Microsoft Mouse. A switch on the bottom of the mouse allows you to toggle the emulation mode from two-button Microsoft emulation to three-button Mouse Systems Mouse emulation. Configure the mouse for use with Windows as follows:
  1. Install the Windows-compatible GENIUS mouse driver that corresponds with the GENIUS mouse setting.


  2. Remove the Microsoft MOUSE.SYS mouse driver from the CONFIG.SYS file.


  3. Install either one of the Mouse drivers supplied with the GENIUS mouse. Use the GMOUSE.SYS driver in the CONFIG.SYS file or the GMOUSE.COM driver in the AUTOEXEC.BAT file.


  4. Save your changes and restart your system.


For further information, contact KYE International technical support.

Additional query words: 3.00 3.00a KBHW 3rdparty

Keywords :
Version : WINDOWS:3.0,3.0a
Platform : WINDOWS
Issue type :


Last Reviewed: November 10, 1999
© 2000 Microsoft Corporation. All rights reserved. Terms of Use.