Disabling Grid Systems Isopoint Mouse on a Grid Laptop 1550SX

ID: Q74179

The information in this article applies to:

Microsoft Windows versions 3.0, 3.0a

SUMMARY

The Grid 1550SX Laptop computer comes with a built-in Isopoint mouse, which is Microsoft bus-mouse-compatible and defaults to IRQ5. However, before you can install a Microsoft mouse, the Isopoint mouse must be disabled.

MORE INFORMATION

Disabling and Enabling the Mouse

You can check the system configuration, by typing config at the MS-DOS prompt.

To disable the grid mouse, type the following at the MS-DOS prompt:
config isopoint=none

To enable it, type the following at the the MS-DOS prompt:
config isopoint=irq5

Microsoft Mouse Installation

If you would like to install a Microsoft of Microsoft-compatible mouse, Grid Systems technical support recommends that you use the following settings.

Isopoint on NONE
Modem on COM2
Serial A set to COM1
Serial B set to COM3

If NO modem is installed, do the following:

Disable the Isopoint mouse.

Set port A (SerialA) to COM1 and port B (SerialB) to COM2, using the following steps:
1. To assign Serial A to Com1, type
  configseriala=com1
2. To assign Serial B to Com2, type
  configserialb=com2

If a modem IS installed, assign it to COM1 by typing the following:

configmodem=com1

If a port does not respond after being assigned, you may need to activate the port by typing:

configseriala=on

-or-

configserialb=on (if set to OFF)

For more information, call Grid Systems.

The products included here are manufactured by vendors independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.

Additional query words: 3.00 3.0 3.0a 3.00a 3rdparty KBHW

Keywords :
Version : WINDOWS:3.0,3.0a
Platform : WINDOWS
Issue type :