The information in this article applies to:
SUMMARYThis article discusses the use of the PS-810, PS-1500, and PS-820 PostScript printers and the Big Kiss laser printer with Microsoft Windows. MORE INFORMATIONPS-810, PS-1500, and PS-820If you use Windows version 2.x, 3.0, or 3.0a with the QMS PostScript printer PS-810, PS-1500, or PS-820, use the PSCRIPT.DRV printer driver.NOTE: The dual-bin capability of these printers is not supported by the PSCRIPT.DRV driver.
QMS also distributes its own PostScript driver for Windows 3.0. This driver
dated 11/03/93, must be used with the QMS PS-2200 and is available from QMS
technical support.
Using the Big Kiss Laser Printer with WindowsThe Big Kiss laser printer supports Epson FX-80 emulation. If the Big Kiss is using ROM version 3.0 or later, it supports Hewlett-Packard (HP) LaserJet emulation.If you have ROM version 3.0, you can check the startup page, which is printed when you turn on the printer, to determine what emulation mode the printer is using. Under Windows 3.0, 3.0a, or 3.1, install the printer driver that corresponds with the emulation mode the printer is set to use. If you do not have ROM version 3.0, you can obtain an update by contacting QMS technical support. Ask for the parts department and order the "Big Kiss ROM Upgrade." The Kiss Plus also supports the same HP LaserJet and Epson emulation modes. The printer needs the Kiss Module 20, 30, or 40 to support HP LaserJet emulation. If you have Module 10, you can either upgrade the ROM, or install the Epson FX-80 printer driver for Windows 3.0. The Big Kiss II supports the Epson FX-80 emulation only. This is because the HP LaserJet emulation does not support two paper trays. The products included here are manufactured by vendors independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability. Additional query words: 3.00 3.00a 3.10
Keywords : |
Last Reviewed: December 2, 1999 © 2000 Microsoft Corporation. All rights reserved. Terms of Use. |