Installation and Usage of MicroSpeed PC-Trackball for Windows

ID: Q83373

The information in this article applies to:

Microsoft Windows versions 3.0, 3.0a

SUMMARY

This article explains how to install MicroSpeed PC-Trackball pointing devices for use with Windows 3.0.

These devices can be operated properly when the "Microsoft or IBM PS/2 mouse driver" option is selected while setting up Windows.

MORE INFORMATION

The MicroSpeed PC-Trackball has four interfaces:

Serial

PS/2 mouse port

Microsoft InPort mouse port

Bus card

Of the four interfaces, the bus card interface is the only one not currently recommended for use with Windows 3.0.

Installing the PC-Trackball with Bus Card Interface

If you use the MicroSpeed PC-Trackball with the bus card interface, you cannot use Windows 3.0 standard or 386 enhanced mode. If you start Windows 3.0 in standard or 386 enhanced mode with this device, the logo screen will briefly appear and then Windows will return to the MS-DOS command prompt. Windows runs correctly in real mode with this bus card.

To work around this problem, connect the PC-Trackball to one of the serial ports and select "Microsoft or IBM PS/2 mouse driver" as the pointing device during Windows setup.

MicroSpeed is aware of this problem and is working on a new driver.

Installing the PC-Trackball Serial, InPort, and PS/2 Mouse Port

Connect the PC-Trackball to the proper port. Do not install any MicroSpeed mouse drivers. If these drivers have been installed, edit the CONFIG.SYS and AUTOEXEC.BAT files. Look for the names PPR.SYS, PPR.COM, and POINTER.BAT and remove them.

If the PC-Trackball is replacing a Microsoft or PS/2 mouse, install for a Microsoft or PS/2 mouse.

If Windows 3.0 is not installed, run the Windows 3.0 Setup program and follow the instructions for installing Windows for use with a Microsoft or PS/2 mouse.

If you are planning to use the PC-Trackball with non-Windows applications, install the Microsoft mouse driver version 7.04 or later in either the CONFIG.SYS or AUTOEXEC.BAT file. The Windows 3.0 Setup program may do this. If it does not, use the Windows EXPAND.EXE utility located on Disk 2 of the Microsoft Windows 3.0 disk to decompress the MOUSE.SY$ file into the root directory as MOUSE.SYS and then edit the CONFIG.SYS file and add the following line:
device=c:\mouse.sys /y

Note: MicroSpeed's KEYMAP.COM program should not be used when running Windows 3.0.

For additional information about MicroSpeed pointing devices, call MicroSpeed Technical Support at (510) 490-1403.

The PC-Trackball is manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.

Additional query words: 3.00 3.00a

Keywords :
Version : WINDOWS:3.0,3.0a
Platform : WINDOWS
Issue type :