Serial Communication Port Settings for HP ColorPro

ID: Q83499

The information in this article applies to:

Microsoft Windows versions 2.x, 3.0a, 3.1, 3.11

SUMMARY

When using a Hewlett-Packard (HP) ColorPro plotter with Windows, serial port communication needs to be configured correctly through the Windows Control Panel.

MORE INFORMATION

To set up a serial communication port for the HP ColorPro in Windows do the following:

Choose the Ports icon from the Control Panel menu.

Choose the appropriate port and choose settings.

Set BAUD rate to 9600 bits per second (BPS).

Set data bits to 8.

Set parity to none.

Set stop bits to 1.

Set flow control to Hardware.

Choose OK.

These settings are common and will work for most serial plotters and printers. For a serial printer, however, a common setting for flow control is None.

To set up a serial communication port for the HP ColorPro in Windows 2.x, do the following:

Start Control Panel from the MS-DOS Executive.

Select the Setup menu and choose the Communications Port command.

Select the appropriate port: COM1 or COM2.

Set BAUD rate to 9600.

Set word length to 8.

Set parity to none.

Set stop bits to 1.

Set handshake to Hardware.

Choose OK.

Each time you go into the Control Panel and choose Communications Port, Windows shows you the settings for COM1 by default. This occurs even if you have never set up COM1. To see the settings for COM2, select COM2 when you are in the Communications Port dialog box. The screen will then show you the settings for COM2.

Additional query words: 3.1 hewlett packard

Keywords :
Version : WINDOWS:2.x,3.0a,3.1,3.11
Platform : WINDOWS
Issue type :