Advanced Button Not Available in Ports Option in Control Panel

ID: Q83752


The information in this article applies to:
  • Microsoft Windows versions 3.1, 3.11


SUMMARY

Under Microsoft Windows operating system version 3.1, if the Windows 3.1 COMM.DRV driver is not installed correctly, the button for the advanced section of Ports in Control Panel is unavailable (dimmed). The correct entry for the Windows 3.1 COM driver in the SYSTEM.INI file is:


   [Boot]
   COMM.DRV=COMM.DRV 


MORE INFORMATION

Windows 3.1 Setup does not upgrade third-party device drivers. Because there is no guarantee that the third-party device drivers are not required to run your installation of Windows, Setup may not be able to complete the installation of Windows 3.1 if the drivers are removed.

If the Communications port driver entry is not correct, do the following:

  1. Edit the SYSTEM.INI file with a text editor and change the COMM.DRV entry as shown above.


  2. Using the EXPAND command (EXPAND.EXE), expand COMM.DRV from the original Windows 3.1 disks by typing the following:
    EXPAND A:COMM.DR_ C:\WINDOWS\SYSTEM\COMM.DRV


NOTE: The COMM.DR_ file is located on Disk 1 of the 1.44 MB (3.5-inch) disk set; and Disk 2 of the 1.2 MB (5.25-inch) and 720K (3.5-inch) disk sets.

Additional query words: 3.10 grey gray

Keywords :
Version : WINDOWS:3.1,3.11
Platform : WINDOWS
Issue type :


Last Reviewed: October 13, 1999
© 2000 Microsoft Corporation. All rights reserved. Terms of Use.