GP Fault in Ventura 4.0 After Installing Windows 3.1
ID: Q84416
|
The information in this article applies to:
-
Microsoft Windows versions 3.1, 3.11
SYMPTOMS
After you install Microsoft Windows version 3.1, you may receive the
following error message:
General Protection Fault Error in module VPWINLIB.DLL
This error occurs in version 4.0 of Ventura for Windows and can be
corrected by freeing up more memory for Ventura's use.
MORE INFORMATION
Ventura 4.0 for Windows requires at least 3 MB of free RAM (conventional
plus extended memory) to run with standard mode Windows. After installing
Windows 3.1, less memory is available to Ventura for operation.
Ventura technical support suggests that you not load unnecessary TSRs and
device drivers that may take up conventional and extended memory (if loaded
into the UMA, upper memory area).
Also, set the BUFFERS statement in the CONFIG.SYS file to at least 15. The
TEMP variable should point to its own TEMP directory contained in the root
directory. (There may be problems with Ventura's operation when the TEMP
variable is set to the root directory, the MS-DOS directory, or a directory
contained on a RAM drive.)
For additional information, contact Ventura Technical Support.
The Ventura products included here are manufactured by vendors
independent of Microsoft; we make no warranty, implied or otherwise,
regarding these products' performance or reliability.
Additional query words:
gpf 3.10 3.11 err msg 3rdparty
Keywords :
Version : WINDOWS:3.1,3.11
Platform : WINDOWS
Issue type :