Windows, Novell NetWare, Incorrect Form Number when Printing
ID: Q85563
|
The information in this article applies to:
-
Microsoft Windows versions 3.1, 3.11
SUMMARY
The following information applies to Microsoft Windows operating
system version 3.1 and Novell NetWare.
When you configure your printer in Control Panel, there is an option to
select a Form Name. These forms are numbered. If you have defined the forms
starting with any number other than zero, you will be prompted for the
incorrect form number by the server to which the printer is connected if a
form change is needed.
For example, if you had defined Form 1 and named it Greenbar and Form
0 had not been defined, the server will prompt you for Form 0 instead
of Form 1 if a form change is needed.
WORKAROUND
To work around this problem, define your forms starting with zero.
MORE INFORMATION
Novell NetWare provides its users with a Forms printing option. This
option allows the network administrator to create several types of
print forms. When a print job is sent to a printer, NetWare checks to
make sure the form selected matches the last form used. If it does not
match, NetWare alerts the designated print console operator that the
paper in that printer needs to be changed.
To Select a Form While in Windows
- Run Control Panel.
- Choose the Printer icon.
- Choose Connect.
- Choose Network.
- Choose Options.
- Select a Form from the Form Name list.
The following two examples demonstrate the correct behavior:
Example One
- Use the Capture command as follows from the MS-DOS prompt, before
starting Windows:
CAPTURE /Q=<printqname> /FORM=1 /NOBANNER
- Restart Windows and send a print job to the server. You will be
prompted as follows:
Mount Form 1 in printer 0. Then use PRINTER 0 MOUNT FORM 1.
- The following command will acknowledge the paper change:
PRINTER 0 MOUNT FORM 1.
Example Two
- Use the Capture command as follows from the MS-DOS prompt before
starting Windows:
CAPTURE /Q=<printqname> /FORM=LETTERHEAD /NOBANNER
- You will be prompted as follows:
Mount form 2(LETTERHEAD) in printer 0. Then use PRINTER 0 MOUNT
FORM 2.
- The following command will acknowledge the paper change:
PRINTER 0 MOUNT FORM 2
Microsoft has confirmed this to be a problem in Windows version 3.1.
We are researching this problem and will post new information here as
it becomes available.
Additional query words:
3.10 3.1 3.11 Netware 2.15
Keywords :
Version : WINDOWS:3.1,3.11
Platform : WINDOWS
Issue type :