The information in this article applies to:
SUMMARYThis article discusses using the LaserMaster printer controller card with Windows. The following issues are covered:
MORE INFORMATIONLaserMaster Controller Card OverviewLaserMaster makes a printer controller card series that allows non-PostScript printers to print PostScript faster and with greater quality than normally obtainable from a PostScript printer cartridge.Windows 3.0 LaserMaster UAE Error MessagesWhen printing from version 3.0 of Excel for Windows, Aldus PageMaker version 4.0, and Micrografx Designer version 3.02, UAEs are generated if a driver earlier than version 3.56 is used.Windows 3.0 Unable to Run in Any ModeIf you are using the LaserMaster card and version 3.2 of the LaserMaster printer driver, Windows cannot run in any mode, if the printer is turned off.To correct this problem, turn on the printer. Version 3.58 of this driver from LaserMaster corrects this problem. LMDPS: DDPI Load Failure (LaserMaster 1000)When installing the LaserMaster 1000 printer driver in Windows 3.0, you may get the error message:This is caused by a faulty installation of the printer driver. Contact LaserMaster for instructions on how to install LaserMaster drivers correctly. Windows 3.1 TrueType and LaserMasterLaserMaster technical support has confirmed that LaserMaster's current printer and video drivers for the GS-1280 do not work with Windows 3.1's TrueType fonts.LaserMaster suggests the following as a workaround for using printer and video drivers version 3.58 and 3.58b with Windows 3.1:
The LaserMaster, Micrografx, and PageMaker products included here are manufactured by vendors independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability. Additional query words: 3.00 3.00a 3.0 3.0a 3.10 3.11 3rdparty Laser Master win31 micrographics micrographx micrografix
Keywords : |
Last Reviewed: December 3, 1999 © 2000 Microsoft Corporation. All rights reserved. Terms of Use. |