WinNT TCP/IP May Reuse TIME-WAIT Connections Prior to 2MSL

ID: Q151418

The information in this article applies to:

Microsoft Windows NT Workstation version 4.0
Microsoft Windows NT Server version 4.0

SYMPTOMS

Under sufficiently high TCP connection rates the Windows NT TCP/IP stack may reuse TCP Control Blocks that are in the TIME-WAIT (also called the 2MSL state) table. This can happen on a heavily loaded Web or FTP server when using graceful TCP closes. Reuse of the Control Blocks may terminate a TCP connection in its TIME-WAIT state prior to the 2MSL time period expiring.

There have been no reports of problems related to this symptom; however the behavior is not RFC-compliant.

CAUSE

In Windows NT the system starts to reuse TCP Control Blocks in TIME-WAIT when the number of active connections goes over 1000. Windows NT 4.0 Service Pack 3 increased this threshold to 2000.

For more information on configuring the TIME-WAIT period for Windows NT, please see the following article(s) in the Microsoft Knowledge Base:

Q149532Windows NT Clients Run Out of Ports

STATUS

Microsoft has confirmed this to be a problem in Windows NT version 4.0. A supported fix is now available, but has not been fully regression-tested and should be applied only to systems experiencing this specific problem. Unless you are severely impacted by this specific problem, Microsoft recommends that you wait for the next Service Pack that contains this fix. Contact Microsoft Technical Support for more information.

This hotfix allows sites with heavy TCP connection rates to configure the threshold of active TCP connections necessary before TCP control blocks are reused.

There are two registry keys that control the use of the TIME-WAIT table:

MaxFreeTcbs is the threshold number of active TCP connections required before TCP Control Blocks in the TIME-WAIT state are reused. Changing MaxFreeTcbs allows the system to avoid reusing TCP Control Blocks.


      HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\Tcpip
         \Parameters\MaxFreeTcbs

      Value Type: REG_DWORD
      Valid Range: 0-0xFFFFFFFF
      Default: 1000 (Windows NT 4.0), 2000 (Windows NT 4.0 Service Pack 3)
      Description: Controls the number of active TCP connections required
                   before TCP control blocks in the TIME-WAIT state are
                   reused.

MaxHashTableSize controls the size of an internal system data structure that controls how fast the system can find a TCP Control Block. The hash table allows the system to access TCP Control Blocks faster and this table should grow if MaxFreeTcbs is configured higher than the default value.



      HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\Tcpip
         \Parameters\MaxHashTableSize

      Value Type: REG_DWORD
      Valid Range: 64-65536 (0x40-0x10000)
      Default: 512
      Description: This value should be set to a power of 2 (e.g. 512,
                   1024, 2048, and so on.) If this value is not a power of
                   2, the system will configure the hash table to the next
                   power of 2 value (for example, a setting of 513 is
                   "rounded up" to 1024.) This value controls how fast the
                   system can find a TCP control block and should be
                   increased if MaxFreeTcbs is increased from the default.

Additional query words: 4.00 prodnt

Keywords : kbnetwork nttcp NTSrvWkst
Version : 4.0
Platform : winnt
Issue type :