Windows NT 4.0 Does Not Support HP ScanJet Interface Card
ID: Q155371
|
The information in this article applies to:
-
Microsoft Windows NT Server version 4.0
-
Microsoft Windows NT Workstation version 4.0
SUMMARY
Windows NT 4.0 does not support the Hewlett-Packard (HP) ScanJet when it
is connected to an HP ScanJet interface card.
Windows NT 4.0 does support the HP ScanJet when it is connected to a
supported SCSI controller.
MORE INFORMATION
There are two versions of the HP ScanJet interface cards (SCSI
Controller):
- The older version of the controller is referred to as the "NCR SDMS
53C400A" and it supports the use of only IRQ 5. Which is not
reconfigurable. All other installed hardware must be using an IRQ
other than 5 or the scanner will not function.
- The newer version of the controller is referred to as the "Symbios
Logic 400a" and it supports a wider variety of IRQ's. It is not
limited to the use of IRQ 5, but the IRQ it does use must not
conflict with any other hardware device installed in the system or
else it will not function appropriately.
For information about how to contact the manufacturers listed above, query in the Knowledge
Base for one of the following articles:
ARTICLE-ID: Q65416
TITLE : Hardware and Software Third-Party Vendor Contact List, A-K
ARTICLE-ID: Q60781
TITLE : Hardware and Software Third-Party Vendor Contact List, L-P
ARTICLE-ID: Q60782
TITLE : Hardware and Software Third-Party Vendor Contact List, Q-Z
The third-party products discussed here are manufactured by vendors
independent of Microsoft; we make no warranty, implied or otherwise,
regarding these products' performance or reliability.
Additional query words:
prodnt
Keywords : kbhw nthw ntprint NTSrvWkst
Version : winnt:4.0
Platform : winnt
Issue type :