Cannot Install DPT SCSI Adapter During Setup on MIPS Platform

• Microsoft Windows NT Server version 4.0
• Microsoft Windows NT Workstation version 4.0

SYMPTOMS

When you are installing Windows NT 4.0 on a NEC RISCStation 2000 MIPS platform with a DPT 3222 EISA RAID SCSI adapter, the onboard NCR 53c700 SCSI adapter is detected by Setup, but the DPT adapter is not detected.

If you press S to install additional adapters, DPTSCSI is selected but Setup shows that the adapter is not installed in the computer.

CAUSE

A note about the MIPS platforms for the DPT 3222 adapter in the Windows NT 4.0 Hardware Compatibility List states:

This adapter cannot be installed during Setup on MIPS systems. Use the SCSI Adapter applet in the Control Panel to add this adapter after NT is installed.

RESOLUTION

After Setup is finished, add the adapter. To do so, follow these steps:

1. In Control Panel, double-click SCSI Adapters.



2. If the DPT adapter is not listed, click the Drivers tab.



3. Click Add.



4. In the Manufacturers box, click DPT Corporation.



5. In the SCSI Adapters box, click NEC EISA SCSI Adapter, and then click OK.

MORE INFORMATION

Windows NT Setup always loads ATDISK as a boot driver on RISC systems because it is often not listed in the firmware as a necessary device. When you attempt to install the DPT driver during Setup, Dptscsi.sys does not load because ATDISK has already claimed the WD1003-compatible ports on the DPT adapter. You cannot install on the drives connected to the DPT 3222 adapter because it is not a boot device, nor can you install to any CD-ROM drive connected to the adapter because it would be necessary to boot from the drive.

Additional query words: prodnt

Keywords : kbhw kbsetup ntsetup ntdriver nthw ntconfig NTSrvWkst
Version : winnt:4.0
Platform : winnt
Issue type :