Windows NT Does Not Load AHA-3940W SCSI Driver

ID: Q158050

The information in this article applies to:
  • Microsoft Windows NT Server version 4.0
  • Microsoft Windows NT Workstation version 4.0

SYMPTOMS

If your computer is configured with an Adaptec AHA-394x adapter on a secondary PCI bus, you may experience either of the following symptoms:

  • Windows NT version 4.0 does not detect the Adaptec AHA-3940W adapter.


  • If you attempt to add the driver using the SCSI Adapters tool in Control Panel, the driver seems to be installed correctly, but is not loaded when you restart the computer.


Any SCSI devices connected to the adapter do not function.


CAUSE

The Adaptec AHA-3940 and AHA-3940W adapters require a motherboard that is PCI 2.0 compliant and that supports PCI-to-PCI bridge chips. The AHA-394x adapters use bridge chips to function as multiple-channel adapters.


RESOLUTION

Install the AHA-394X adapter on the primary PCI bus and then install the driver. To install the driver, follow these steps:

  1. In Control Panel, double-click SCSI Adapters.


  2. Click the Drivers tab, and then click Add.


  3. In the Manufacturers box, click Adaptec.


  4. In the SCSI Adapter box, click "Adaptec AHA-294X/AHA-394X or AIC-78XX PCI SCSI Controller," and then click OK.


  5. When you are prompted to restart your computer, click Yes.



MORE INFORMATION

This behavior occurs only when the adapter is installed in a slot that is on a secondary PCI bus (or, in other words, when the SCSI chips are behind two PCI-to-PCI bridges, one on the motherboard and one on the adapter).

Additional query words: prodnt

Keywords : kbenv kbhw ntsetup nthw ntconfig NTSrvWkst
Version : 4.0
Platform : winnt
Issue type :


Last Reviewed: January 27, 1999
© 2000 Microsoft Corporation. All rights reserved. Terms of Use.