SET: Screen Displays "Boot 2>" Prompt After First Setup Reboot

• Microsoft Windows NT Workstation versions 3.5, 3.51, 4.0
• Microsoft Windows NT Server versions 3.5, 3.51, 4.0

SYMPTOMS

When you perform a new install of Windows NT, the prompt "Boot 2>" is displayed on the screen after the reboot from text setup to GUI setup.

CAUSE

This condition can occur if the product System Commander from V Communications was previously installed on the target hard disk. This error can also appear if the master boot record code is corrupted.

WORKAROUND

There are three ways to work around this problem:

1. Low-level format the drive.



2. Use the System Commander uninstall.



3. After backing up the mbr using disksave.exe, run fdisk /mbr against the system and the machine should get past this error.

STATUS

The third-party products discussed here are manufactured by vendors independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.

Additional query words: system commander boot 2>

Keywords : kb3rdparty kbsetup ntsetup
Version : 3.5 3.51 4.0
Platform : winnt
Issue type :