Err Msg: Setup Was Unable to Verify Your <X>: Drive

• Microsoft Windows NT Workstation versions 3.5, 3.51, 4.0
• Microsoft Windows NT Server versions 3.5, 3.51, 4.0

SYMPTOMS

When you are running Windows NT 4.0 Setup from the three boot floppy disks, you may receive the following error message on the third disk when Setup performs a check of your hard disks:

Setup was unable to verify your <X> drive

CAUSE

This occurs if Autochk.exe cannot check the drive or cannot be loaded. Most likely, Windows NT Setup detected a CD-ROM drive but could not read from it. Because this is not a fatal error, you can continue, but you may have problems copying the files from your CD-ROM drive. This can also lead you to believe that your hard disk is damaged, but may be just a bad CD- ROM or failing CD-ROM drive or controller.

RESOLUTION

If the message occurs because of a CD-ROM that cannot be read, try the following steps to work around the problem:

1. For a drive using the FAT file system, copy the I386 folder to the hard disk and then install from the hard disk using the WINNT /B command.



2. For a drive using the NTFS file system, try replacing the CD-ROM, the CD-ROM drive, or the CD-ROM controller.

Additional query words: Autochk autocheck

Keywords : kberrmsg kbsetup ntsetup
Version : 4.0
Platform : winnt
Issue type :