Cannot Access Volume Serial Number with 32-Bit File Access

ID: Q113235


The information in this article applies to:
  • Microsoft Windows for Workgroups version 3.11


SYMPTOMS

When you type vol at an MS-DOS command prompt within Windows for Workgroups, only the volume label line is returned. For example, you receive

Volume in drive C is MYHARDDRIVE
but you do not receive the volume serial number entry, for example:
Volume Serial Number is 16E1-2263


CAUSE

If you have 32-bit file access enabled, you cannot access the volume serial number entry line in an MS-DOS session within Windows for Workgroups or when running MS-DOS-based applications under Windows for Workgroups.


WORKAROUND

If you have a program that requires the serial number, you have two options:

  • Disable 32-bit file access. To do this, choose the 386 Enhanced icon in Control Panel, choose Virtual Memory and Change, and then clear the 32-Bit File Access check box.

    -or-


  • Run the application outside Windows.



MORE INFORMATION

Some third-party software packages use the hard disk drive serial number as part of a copy detection/protection scheme. When the software is installed, it keeps an internal record of the hard disk drive serial number and does not work correctly if you start the software in an MS-DOS session when 32- bit file access is active. The software package checks for the serial number, but since it is no longer available to MS-DOS, the authentication process fails, and the software does not load.

Additional query words: vfat 3.11 Copy-protect Virtual

Keywords :
Version : WINDOWS:3.11
Platform : WINDOWS
Issue type :


Last Reviewed: September 23, 1999
© 2000 Microsoft Corporation. All rights reserved. Terms of Use.