The information in this article applies to:
SYMPTOMSSometimes when I run CodeView, I get an message. CAUSE
Internal Debugger Error messages are usually caused by problems in
your MS-DOS environment; the most likely cause is the presence of
memory-resident software, commonly referred to as TSRs (terminate-
and-stay-resident software).
RESOLUTION
CodeView Versions 2.0 and later have become increasingly more
sensitive to TSRs. If you receive an Internal Debugger Error message,
or you are experiencing strange problems within CodeView, make sure
you are running CodeView with no memory-resident software loaded
(including, but not limited to, device drivers, screen savers,
keyboard enhancers, command-line editors, etc.). Disabling your
resident software, but not rebooting, may not completely remove its
interference, so be sure to "boot clean" when trying to resolve a
problem of this type.
Additional query words: 2.20 3.00
Keywords : kb16bitonly |
Last Reviewed: October 28, 1999 © 2000 Microsoft Corporation. All rights reserved. Terms of Use. |