Changing PWB Build from .COM to .EXE Causes File Conflict

ID: Q69750


The information in this article applies to:
  • Microsoft Programmer's Workbench for MS-DOS, versions 1.0, 1.1


SUMMARY

Under MS-DOS, the Programmer's WorkBench (PWB) will allow the build target for a project to be a .COM file or a .EXE file. If you are in the middle of a project and you switch the build options from one of these file types to the other, the previously built files may cause unexpected results when you try to run or debug the program.

This problem is the result of the ordering in which MS-DOS invokes files, and not a problem with PWB. If a filename is entered at the MS-DOS command prompt, MS-DOS first looks for a file with a .COM extension. If no .COM file is found, then DOS searches for a .EXE file. Therefore, if both a .COM and a .EXE file with the same base name (for example, PROJ.COM and PROJ.EXE) appear in the same directory, MS-DOS will always invoke the .COM version (even if the .EXE extension is explicitly specified).


MORE INFORMATION

Within PWB, a request to run your program causes the entire filename to be passed to MS-DOS for execution, but MS-DOS prevents an .EXE from overriding a .COM file of the same name. So, if you start a project with the target as a .COM file and later switch it to an .EXE, then the existing .COM file always supersedes the new .EXE and is unexpectedly run whenever you try to execute the program.

The only way to ensure that you are dealing with the correct .EXE file is to delete the previous .COM file that you are no longer trying to build.

It should also be noted that if you invoke CodeView from inside PWB, PWB will pass the correct filename (.COM or .EXE) to CodeView, but outside of PWB, the reverse of the above situation may exist. This results from the fact that CodeView always assumes that the file you specify to debug is an .EXE, unless the .COM extension is explicitly specified on the CodeView command line. Thus, if you switch your project from an .EXE to a .COM and both files exist in the current directory, the .EXE will be inadvertently brought up in CodeView when you invoke the debugger from the MS-DOS prompt if you forget to include the .COM extension.

Additional query words: kbinf 1.00 1.10 PWBIss

Keywords : kb16bitonly
Version : MS-DOS:1.0,1.1
Platform : MS-DOS
Issue type :


Last Reviewed: October 29, 1999
© 2000 Microsoft Corporation. All rights reserved. Terms of Use.