Sharing IRQs with the Windows 3.0 Communications Driver

• Microsoft Windows Device Development Kit (DDK) for Windows, version 3.0

SUMMARY

The communications driver shipped with version 3.0 of the Microsoft Windows graphical environment runs in enhanced mode, it can share serial communication IRQ between COM ports if the hardware is compliant. This can occur on equipment with the Industry Standard Architecture (ISA), the Extended Industry Standard Architecture (EISA), or the Micro-Channel Architecture (MCA).

MORE INFORMATION

The communications driver supplied with Windows 3.0, COMM.DRV, can share IRQs between two serial communication boards when Windows runs in enhanced mode. However, this ability is very dependent on the hardware and may not work in all cases.

In the default configuration, COM1 and COM3 are placed on IRQ 4; COM2 and COM4 are placed on IRQ 3. To use COM2 and COM4 at the same time, for example, the two ports must successfully share IRQ 3. To accomplish this, when the COMM.DRV receives an interrupt, it checks each COM port that is currently open on the IRQ to determine if the port requires service. After COMM.DRV services the interrupt for one port, it checks any other ports connected to that IRQ until it determines that no ports require service. Then COMM.DRV executes an EOI instruction and an IRET instruction.

IRQ sharing works correctly only if the COM adapters cooperate with each other. Some adapters mask the interrupt request such that other adapters on the same IRQ line cannot send an interrupt request to the interrupt controller. By default, the COMM.DRV supports IRQ sharing on an EISA or an MCA machine because the COM ports probably share an IRQ with each other or with another device in the system. On an ISA machine, where the chances of IRQ sharing are much lower, the user can enable IRQ sharing by setting the ComIRQSharing flag in the [386Enh] section of the SYSTEM.INI initialization file. For more information, see the documentation for the ComIRQSharing flag in the SYSINI2.TXT file that the Windows setup program places in the Windows directory (by default, C:\WINDOWS).

Note that all the extra processing required to share IRQs creates overhead. On a system where a the COM ports do not share an IRQ with any other device, disabling IRQ sharing with the ComIRQSharing switch provides a minor performance improvement.

Additional query words: 3.00 DDKVCD

Keywords :
Version : :3.0
Platform :
Issue type :