DOCERR: How CN_RECEIVE Events Are Generated

ID: Q101415


The information in this article applies to:
  • Microsoft Windows Software Development Kit (SDK) 3.1


SUMMARY

WM_COMMNOTIFY messages with CN_RECEIVE notifications are enabled when EnableCommNotification() is called with any number but -1 in the cbWriteNotify parameter. CN_TRANSMIT notifications are enabled when the cbOutQueue parameter is any number but -1. The CN_RECEIVE notifications are generated when either the number of characters in the receive queue exceeds cbWriteNotify, or a time-out occurs. Similarly, CN_TRANSMIT notifications are generated when the number of characters in the output queue drops below the cbOutQueue parameter.


MORE INFORMATION

When the COMM.DRV is loaded, it calls CreateSystemTimer() to create a 100 millisecond timer. When the timer goes off, COMM.DRV loops through all open ports, and does the "time-out check." The timer period is not configurable.

A CN_RECEIVE notification is generated if at receive interrupt time the following are true:

  • CN_RECEIVE notification is enabled.


  • The number of characters in the receive queue exceeds cbWriteNotify.


  • The number of characters in the receive queue has been below cbWriteNotify since the last CN_RECEIVE notification.


  • -or-

The following are true at time-out check:

  • CN_RECEIVE notification is enabled.


  • The port has at least one character in its receive queue.


  • The number of characters in the receive queue is less than cbWriteNotify.


  • A time-out CN_RECEIVE has not already been sent since the last character arrived at the port.


A CN_TRANSMIT notification is generated if at transmit interrupt time the following are true:

  • CN_TRANSMIT notification is enabled.


  • The number of characters in the transmit queue is less then cbOutQueue.


  • The number of character in the transmit queue has been above cbOutQueue since the last CN_TRANSMIT notification.


The Windows 3.1 Software Development Kit (SDK) documentation for EnableCommNotification() contains an incorrect sentence in the comments section:
Similarly, a WM_COMMNOTIFY message in which the CN_RECEIVE flag is set is sent only when the output queue is larger than the number of bytes specified in the cbOutQueue parameter.
This should be replaced by:
Similarly, a WM_COMMNOTIFY message in which the CN_TRANSMIT flag is set is sent only when the number of bytes in the output queue first exceeds and then falls below the number of bytes specified in the cbOutQueue parameter.
COMM.DRV has a bug that can generate extra CN_RECEIVE or CN_TRANSMIT notifications. For additional information, please see the following article in the Microsoft Knowledge Base:
Q101420 BUG: Extra CN_RECEIVE/CN_TRANSMIT Events

Additional query words: 3.10 no32bit docerr

Keywords : kb16bitonly
Version : WINDOWS:3.1
Platform : WINDOWS
Issue type :


Last Reviewed: November 4, 1999
© 2000 Microsoft Corporation. All rights reserved. Terms of Use.