ScsiPortLogError

VOID
ScsiPortLogError(

IN PVOID HwDeviceExtension,
IN PSCSI_REQUEST_BLOCK Srb,/* optional */
IN UCHAR PathId,
IN UCHAR TargetId,
IN UCHAR Lun,
IN ULONG ErrorCode,
IN ULONG UniqueId
);

ScsiPortLogError logs errors to the system event log when a miniport driver or its HBA detects a SCSI error condition.

Parameters

HwDeviceExtension

Points to the miniport driver's per-HBA storage area.

Srb

Points to a SCSI request block if one is associated with the error. Otherwise, this parameter is NULL.

PathId

Identifies the SCSI bus.

TargetId

Identifies the target controller or device on the bus.

Lun

Identifies the logical unit number of the target device.

ErrorCode

Specifies an error code indicating one of the following values as the type of error:

Values Meaning
SP_PROTOCOL_ERROR Indicates the miniport driver detected a SCSI bus protocol error.
SP_BUS_PARITY_ERROR Indicates a SCSI bus parity error was detected.
SP_INTERNAL_ADAPTER_ERROR Indicates an internal HBA error was detected.
SP_UNEXPECTED_DISCONNECT Indicates that a target disconnected unexpectedly.
SP_INVALID_RESELECTION Indicates a logical unit reselected unexpectedly or with an invalid queue tag.
SP_BUS_TIME_OUT Indicates a SCSI bus connection to a logical unit timed out.
SP_REQUEST_TIMEOUT Indicates an operation to the controller has timed out.
SP_IRQ_NOT_RESPONDING Indicates the HBA is not interrupting when expected.
SP_BAD_FW_ERROR Indicates the driver has detected bad or old firmware. The device will not be used.
SP_BAD_FW_WARNING Indicates the driver has detected a card with old or bad firmware, which can result in reduced performance or functionality.

UniqueId

Specifies a unique identifier for the error. This value differentiates the current error from other errors with the same ErrorCode. For some miniport drivers, this identifies the line of code where the error was detected. For others, it is additional information returned by the HBA.

Comments

A miniport driver should log all real hardware errors. However, it should not log common operational errors, such as selection time outs or bus resets it detects.

See Also

ScsiPortNotification