The Service Install section installs the service listed in the AddService entry of the Services section:
[install-section-name_ServiceInstallSection]
DisplayName=[name]
ServiceType=type-code
StartType=start-code
ErrorControl=error-control-level
ServiceBinary=path-to-service
LoadOrderGroup=[load-order-group-name]
Dependencies=+depend-on-group-name[[,depend-on-service-name]...]
StartName=[driver-object-name]
name
Optional. A friendly name for the service.
type-code
Specifies the type of driver. This can be any type allowed by the CreateService function. See the Win32 SDK online documentation for more information.
start-code
Specifies when to start the driver. One of the following:
SERVICE_BOOT_START (0x0)
Indicates a driver started by the operating system loader. This code should only be used for drivers that are essential to loading the OS.
SERVICE_SYSTEM_START (0x1)
Indicates a driver started during OS initialization.
SERVICE_AUTO_START (0x2)
Indicates a driver started by the Service Control Manager during system startup.
SERVICE_DEMAND_START (0x3)
Indicates a driver started on demand by the Service Control Manager.
SERVICE_DISABLED (0x4)
Indicates a driver that cannot be started.
error-control-level
Specifies the level of error control as follows:
CRITICAL (0x3)
If the driver fails to load, fail the attempted startup. If the startup is not using the LastKnownGood control set, switch to LastKnownGood. If the startup attempt is using LastKnownGood, run a bug-check routine.
SEVERE (0x2)
If the startup is not using the LastKnownGood control set, switch to LastKnownGood. If the startup attempt is using LastKnownGood, continue on in case of error.
NORMAL (0x1)
If the driver fails to load or initialize, startup should proceed, but display a warning.
IGNORE (0x0)
If the driver fails to load or initialize, startup proceeds. No warning is displayed.
path-to-service
The path to the binary for the service.
load-order-group-name
Optional. Identifies the load order group of which this driver is a member. Examples of groups are: pointer, port, primary disk, and so forth. For detailed discussion of load order groups and controlling load order, see Chapter 1.
+depend-on-group-name
Optional. Specifies a load order group on which the driver depends. The driver is started only if at least one member of the specified group has been started. For detailed discussion of load order groups and controlling load order, see Chapter 1.
depend-on-service-name
Optional. Specifies a service that must be running before this driver is started.
driver-object-name
Optional. If type-code specifies a Kernel driver or a file system driver, this name is the Windows NT driver object name that the I/O Manager uses to load the device driver.
The following example shows a typical Service Install section:
[mouclass_Service_Inst]
DisplayName = %mouclass.SvcDesc%
ServiceType = 1 ; SERVICE_KERNEL_DRIVER
StartType = 1 ; SERVICE_SYSTEM_START
ErrorControl = 1 ; SERVICE_ERROR_NORMAL
ServiceBinary = %12%\mouclass.sys
LoadOrderGroup = Pointer Class