All of the Windows NT internal configuration information is stored in the Registry. It is critical to have up-to-date, reliable backups of this information. There are several ways to back up the all or part of the Registry, and you should have redundancy in this area.
If you have a backup device installed on your computer, you can include the Registry in normal backups. You have to specifically select this option in the Windows NT tape backup program Ntbackup.exe. Third-party Windows NT-compatible backup software might also require that you take specific action to back up the Registry. Be sure to test your Registry backup and restore procedures.
Note
Windows NT Backup can only back up the Registry on the local system. You cannot use Windows NT Backup to back up a computer's Registry over the network.
After any change in the configuration of the operating system, including adding new software, you should use the Repair Disk program, Rdisk.exe, to update files in the %systemroot%\Repair folder, and create a new Emergency Repair Disk. For information about using the Repair Disk program, see "Creating an Emergency Repair Disk," presented later in this chapter. It is a good idea to make a copy of the Emergency Repair Disk and store it in a separate location, perhaps off site.
You can use the Windows NT Registry Editor, Regedt32.exe, to save and restore Registry keys.
The Windows NT Server Resource Kit CD contains utilities that enable you to back up and restore all or part of the Registry. For information about the Registry Backup (Regback.exe) and Registry Restore (Regrest.exe) utilities, see Rktools.hlp.
The HKEY_LOCAL_MACHINE\SYSTEM key contains configuration information that Windows NT uses during startup. Even though this key is copied to the Emergency Repair Disk when you use Repair Disk program, there are times that you might want to restore this key from another disk. For more information, see "Restoring the SYSTEM Key," presented later in this chapter.
You can save the SYSTEM key by using either Disk Administrator or the Windows NT Registry Editor (Regedt32.exe). The primary difference between these two methods is that the Disk Administrator always saves the key to a floppy disk, whereas you can specify any disk by using the Registry Editor.
Note
The %systemroot%\System32\Config\System file is usually larger than the SYSTEM key saved by using Disk Administrator or Registry Editor. The smaller size results because the two programs compact the file before copying it to eliminate internal fragmentation and holes.
1. On the Partition menu, click Configuration.
2. On the Configuration menu, click Save. A message is displayed describing what will be saved and where you should save it.
3. Insert any floppy disk with enough unused space to hold the configuration information (about 512K). Using the Windows NT startup floppy disk is highly recommended.
4. Click OK to write the data to the floppy disk.
1. Run Registry Editor (Regedt32.exe).
2. Click the HKEY_LOCAL_MACHINE\SYSTEM key. On the Registry menu, click Save key.
3. Enter the path to the file where you want to save the key.
The HKEY_LOCAL_MACHINE\SYSTEM\DISK subkey in the Registry contains configuration information about currently defined drive letters, volume sets, stripe sets, stripe sets with parity, and mirror sets, as well as CD-ROM mappings and drive mappings. Any time that you make changes to your disk configuration, Windows NT updates the DISK subkey. You should save this key whenever you make changes that affect it, such as:
Having a backup is useful in situations when you do not want to restore the entire Registry or the entire SYSTEM key, such as the following:
For example, if you have changed a SCSI controller, restoring the entire SYSTEM key might make it difficult to start the computer. Restoring the DISK subkey enables you to have current disk configuration information without changing anything else in the Registry.
Note
The DISK subkey does not exist the first time that you start Windows NT. Disk Administrator creates the key the first time that you run it.
1. Run Registry Editor (Regedt32.exe).
2. Click the HKEY_LOCAL_MACHINE\SYSTEM\DISK subkey. On the Registry menu, click Save key.
3. Enter the path to the file where you want to save the key.