EndConnectionSite Property Example

This example assumes that myDocument already contains two shapes attached by a connector named "Conn1To2." The code adds a rectangle and a connector to myDocument. The end of the new connector will be attached to the same connection site as the end of the connector named "Conn1To2," and the beginning of the new connector will be attached to connection site one on the new rectangle.

Set myDocument = Worksheets(1)
With myDocument.Shapes
    Set r3 = .AddShape(msoShapeRectangle, _
        100, 420, 200, 100)
    With .Item("Conn1To2").ConnectorFormat
        endConnSite1 = .EndConnectionSite
        Set endConnShape1 = .EndConnectedShape
    End With
    With .AddConnector(msoConnectorCurve, _
            0, 0, 10, 10).ConnectorFormat
        .BeginConnect r3, 1
        .EndConnect endConnShape1, endConnSite1
    End With
End With