CDC::IntersectClipRect 

virtual int IntersectClipRect( int x1, int y1, int x2, int y2 );

virtual int IntersectClipRect( LPCRECT lpRect );

Return Value

The new clipping region’s type. It can be any one of the following values:

Parameters

x1

Specifies the logical x-coordinate of the upper-left corner of the rectangle.

y1

Specifies the logical y-coordinate of the upper-left corner of the rectangle.

x2

Specifies the logical x-coordinate of the lower-right corner of the rectangle.

y2

Specifies the logical y-coordinate of the lower-right corner of the rectangle.

lpRect

Specifies the rectangle. You can pass either a CRect object or a pointer to a RECT structure for this parameter.

Remarks

Creates a new clipping region by forming the intersection of the current region and the rectangle specified by x1, y1, x2, and y2. GDI clips all subsequent output to fit within the new boundary. The width and height must not exceed 32,767.

CDC OverviewClass MembersHierarchy Chart

See Also   ::IntersectClipRect, CRect, RECT