int SetPolyFillMode( int nPolyFillMode );
Return Value
The previous filling mode, if successful; otherwise 0.
Parameters
nPolyFillMode
Specifies the new filling mode. This value may be either ALTERNATE or WINDING. The default mode set in Windows is ALTERNATE.
Remarks
Sets the polygon-filling mode.
When the polygon-filling mode is ALTERNATE, the system fills the area between odd-numbered and even-numbered polygon sides on each scan line. That is, the system fills the area between the first and second side, between the third and fourth side, and so on. This mode is the default.
When the polygon-filling mode is WINDING, the system uses the direction in which a figure was drawn to determine whether to fill an area. Each line segment in a polygon is drawn in either a clockwise or a counterclockwise direction. Whenever an imaginary line drawn from an enclosed area to the outside of a figure passes through a clockwise line segment, a count is incremented. When the line passes through a counterclockwise line segment, the count is decremented. The area is filled if the count is nonzero when the line reaches the outside of the figure.
CDC Overview | Class Members | Hierarchy Chart
See Also CDC::GetPolyFillMode, CDC::PolyPolygon, ::SetPolyFillMode