Routing and Remote Access Service

Previous Topic Next Topic

Refreshing the Configuration

You cannot remove the Routing and Remote Access service using Add/Remove Programs in Control Panel; however, you can refresh the configuration by disabling the Routing and Remote Access service and then reconfiguring it. Disabling the service removes all Routing and Remote Access registry settings.

To refresh the configuration of the Routing and Remote Access service

  1. Run Routing and Remote Access from the Administrative Tools folder.
  2. For the appropriate computer, right-click the server icon and select Disable Routing and Remote Access.
  3. When prompted with the warning dialog box, select Yes.
  4. To configure the Routing and Remote Access service configuration, use the enable and configure procedure.

note-icon

Note

If you disable the Routing and Remote Access service, all current configuration for the service, including routing protocol configuration and demand-dial interfaces, is removed and all currently connected clients are disconnected.

© 1985-2000 Microsoft Corporation. All rights reserved.