Netsh Commands

To view multicast tables and gather information to aid in the troubleshooting of multicast routing and forwarding problems, use the following netsh command lines:

• netsh routing ip show mfe

  Displays the entries in the multicast forwarding table. This is equivalent to the multicast forwarding table available from the Routing and Remote Access snap-in.

• netsh routing ip show mfestats

  Displays packet statistics and input and output interface information for entries in the multicast forwarding table. This is equivalent to the multicast statistics window available from the Routing and Remote Access snap-in.

• netsh routing ip igmp show grouptable

  Displays IGMP host group membership information for all host groups registered on all interfaces configured for IGMP router mode. This is equivalent to the IGMP group table in the Routing and Remote Access snap-in.

• netsh routing ip igmp show ifstats

  Displays IGMP statistics for each interface.

• netsh routing ip igmp show iftable

  Displays host group membership information for host groups registered on a specific interface configured for IGMP router mode. This is equivalent to the IGMP interface group table in the Routing and Remote Access snap-in.

• netsh routing ip igmp show rasgrouptable

  Displays the group table for the Internal interface used by the remote access server.

• netsh routing ip igmp show proxygrouptable

  Displays the group table for the IGMP proxy mode interface.

© 1985-2000 Microsoft Corporation. All rights reserved.