ILockBytes::ReadAt

This method reads a specified number of bytes starting at a specified offset from the beginning of the array.

At a Glance

Header file: Objbase.h
Windows CE versions: 2.0 and later

Syntax

HRESULT ReadAt( ULARGE_INTEGER ulOffset, void * pv,
ULONG
cb, ULONG * pcbRead );

Parameters

ulOffset

[in] Specifies the starting point from the beginning of the byte array for reading data.

pv

[in] Pointer to the buffer into which the byte array is read.

cb

[in] Specifies the number of bytes of data to attempt to read from the byte array.

pcbRead

[out] Pointer to a location where this method writes the actual number of bytes read from the byte array. You can set this pointer to NULL to indicate that you are not interested in this value. In this case, this method does not provide the actual number of bytes read.

Return Values

One of the values described in the following table is returned.

Value Description
S_OK Indicates that the specified number of bytes were read, or the maximum number of bytes were read up to the end of the byte array.
E_FAIL Data could not be read from the byte array.
E_PENDING Asynchronous Storage only: Part or all of the data to be read is currently unavailable.
STG_E_ACCESSDENIED The caller does not have permission to access the byte array.
STG_E_READFAULT The number of bytes to be read does not equal the number of bytes that were acutally read.

Remarks

ILockBytes::ReadAt reads bytes from the byte array object. It reports the number of bytes that were actually read. This value may be less than the number of bytes requested if an error occurs or if the end of the byte array is reached during the read.

It is not an error to read less than the specified number of bytes if the operation encounters the end of the byte array. Note that this is the same end-of-file behavior as found in MS-DOS FAT file system files.