4.2.13 Backspacing

The CM_OCD_BS box contains the printer command or commands which cause a
backspace. This command is only required for printers that support device
fonts which use byte-paired character-translation tables (CTTs). For more
information about CTTs, see Section 7.2, Creating a Character-Translation
Table.


Diconix 150 Plus

For the Diconix 150 Plus printer, the Backspace command (0x08) moves the
cursor in the negative x-direction by the width of the current font's space
character.

To specify the Backspace command, type the following in the CM_OCD_BS box:

    \x08


HP LaserJet IIP

For the HP LaserJet IIP printer, the Backspace command (0x08) moves the
cursor in the negative x-direction by the width of the current font's space
character.

To specify the Backspace command, type the following in the CM_OCD_BS box:

    \x08